Lexus 69802-33020 Regulator Sub-Assy, Front Door Window, LH

You can Select Your Vehicle to check if 69802-33020 fits your vehicle.

For front window regulator/motor assembly removal, begin by removing the door trim panel and plastic water shield. Remove the window glass assembly. For power-operated windows, disconnect the electrical connector from the window regulator motor. On Avalon and Solara models, take out the regulator/motor assembly mounting bolts. Before removing the bolts, mark the position of the rear bolt of the upper roller guide. Remove the lower roller guide (equalizer) bolts, followed by the six screws holding the regulator/motor (or crank assembly on non-power window models) to the door. Pull out the equalizer arm and regulator assemblies through the service hole in the door frame to remove them. The installation process is the reverse of removal, and it's recommended to lubricate the rollers and wear points on the regulator with white grease before installation.For rear window regulator/motor assembly removal, follow a similar procedure. Remove the door trim panel and plastic water shield, then the window glass assembly. Disconnect the electrical connector from the window regulator motor for power-operated windows. Remove the regulator/motor assembly mounting bolts. The rear regulator/motor assembly is mounted similarly to that of the front doors on all models. Remove the equalizer bar and raise the regulator assembly through the service hole in the door frame to remove it. Installation is the reverse of removal, and lubricating the rollers and wear points on the regulator with white grease before installation is recommended.Please note that the information provided is a summary of the removal and installation steps for window regulator/motor assemblies. Actual procedures may vary depending on the specific vehicle model and year. Always refer to the vehicle's service manual or consult a professional mechanic for detailed and accurate instructions.